Porsche 718 Forum banner
1 - 1 of 1 Posts

· Registered
1,213 Posts
Discussion Starter · #1 ·
I haven't seen this mentioned before so thought I'd throw it out to the crowd. My SA took time to instruct me to make sure I get the rubber seal on the top of the frunk properly seated after removing/replacing the battery cover. Once the battery cowling is put back into place, you have to gently lift the rear part of the rubber seal to make sure it is in position covering the cowling that was removed/replaced. Otherwise water can leak into the frunk I'm guessing.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.